Secondo - Finishing oil for wooden floors and furniture for easy restoration without sanding

Use
Interior: Ideal for floors, stairs, furniture, kitchen cabinets, vanities, windows and doors.

Colors*
Rich and opaque, our colors are carefully prepared to bring out the natural grain of the wood. Durable, our oils allow the wood to breathe while providing the desired effect.

Benefits
Faint odor;
Easy to apply;
Good coverage;
Preserves the natural appearance of the wood;
Protects the wood against moisture;
Let the wood breathe;
Resistant to wear and scratches;
Waterproofs wooden surfaces;
Protects against water, alcohol and stains;
Durable protection;
Does not lift the wood fibers;
Does not create a film on the surface of the wood;
Easy and sandblast-free refreshing and restoration;
Easy to repair on an as-needed basis;
Easy to maintain;
Available in 2 colors.

Manual application:

1. Mix well with a stick before and during
the application.
2. Apply in a thin layer, using circular motions.
circular motions, until the wood is saturated using a
DYEING PAD, made of a POLYCOTTON CLOTH,
a dye applicator, a short-pile roller or
with a paintbrush.
3. After 5 to 15 minutes, wipe the surface dry with
Clean polycotton cloths to remove all
excess oil.
4. Clean the tools and accessories used with the
TOOL CLEANER AND THINNER and soak the
rags saturated with oil in water before throwing them in the
garbage can.
5. Allow to dry for 18 to 24 hours.
6. Before applying the second coat, if more than 72
Hours have passed since the first application,
sand using 120 grit sandpaper and
dust off before repeating all the steps
previous ones.
7. For application on furniture, it is
recommended to sand with 000000 steel wool or
Use 800 grit sandpaper between coats to smooth the finish.

Mechanical application:

1. Mix well with a stick before and during
the application.
2. Apply the oil using a trowel or roller.
short hair.
3. After 5 to 15 minutes, polish using a polisher.
floor and a white or beige disc.
4. If excess oil remains after polishing, place a
Place a polycotton cloth under the disc and proceed to
Use the polisher again to remove excess oil.
Change the cloth when it is saturated with oil.
5. It is also possible to apply the oil directly with
the polisher by adding a small amount of oil to
center of the disc and rub until the product is
distributed evenly.
6. Clean the tools and accessories used with the
TOOL CLEANER AND THINNER and soak the
rags saturated with oil in water before throwing them in the
garbage can.
7. Allow to dry for 18 to 24 hours.
8. Before applying the second coat, if more than 72
Hours have passed since the first application,
sand using 120 grit sandpaper and
dust off before repeating all the steps
previous ones.

1. Apply at a temperature above 15°C.
2. The wood must be clean, dry and pre-treated with
UNO coloring oil.

Color 00 – Colorless provides an amber finish. It is used to cover Uno colored oils as well as Uno Colorless.

Color 22 – Natural is slightly bleached and is used to coat Uno 19 – White and 22 – Natural oils, thus preventing yellowing. It helps to better preserve the whiteness of light-colored woods (pine, maple, cherry, spruce, beech, aspen, etc.). It is strongly recommended to test beforehand on open-grained woods and on colored woods (oak, walnut, mahogany, elm, etc.).

For a softer, smoother finish, lightly sand between the last two coats with 600 or 800 grit sandpaper.